All-in-One for better looking ducts

All-in-One for better looking ducts
All-in-One for better looking ducts
All-in-One Support consists of semi-circular hangers, made from anodized aluminum, sewn into pockets on the exterior of the duct at fixed intervals. These come pre-installed from the factory, which significantly reduces installation time compared to the systems offered by other manufacturers. The All-in-One support are easily removable for maintenance purposes. The appropriate suspension support depends on the diameter of the duct. The AiO Support will cover 180° of the duct’s circumference up to Ø1220 [Ø48”]. For diameters above Ø1220 [Ø48”], hanger coverage decreases due to shipping constraints. All-in-One provides additional support for 90° elbows.
 
All-in-One holding the fabric ducts open even when air is offAll-in-One hoops are supprotníng the ducts on a FabricAir cable system
       
Is it metal or fabric?
 
visually appealing
always open even at shut down (99%)
minimum strain during startup
built in hoops means faster installation
•minor tool requirements
aluminum rails or cable (H-rails or T-rails, cable or od)
duct is supported 180°
fully supported elbows
 
 
Comparison  

Classic

with and without air turned on

All-in-One

with and without air turned on

All-in-One suspensions compare wih classic, h-rail Compare ll-in-on for cables with cassic suspension
Regular systems (Classic H-rail) with single suspension turn flat when the air is shut off. This is not the case with All-in-One systems. Only a slight change of the circular shape occurs with All-in-One when the air is turned off

Type 1 cable suspension is used to suspend classic as well as All-In-One FabricAir ducts. 

Type 3 T-rail suspension is convenient frequent laundry, as it is quick and easy to remove and replace the ducts. 

Type-5 H-rail suspension is a method of suspending FabricAir ducts. The H-rail, so named because it looks like a H in the cross section, is made out of anodized aluminum, making it an excellent choice for corrosive environments.

Type 8 H-rail suspension is a method of suspending FabricAir ducts. The H-rail, so named because it looks like an H in the cross section, is made out of anodized aluminum, making it an excellent choice for corrosive environments. 

Hoops for suspension are used in conjunction with the All-in-One systems. The hoops are made of anodized aluminum and help to keep the duct from "cheating" towards the center of the duct when there is no airflow.

2003-G027-000.pdf
Suspension document:
General -G027

Suspension System general files