Type 1 cable suspension is used to suspend classic as well as All-In-One FabricAir ducts.


All-in-One Support (AiO) consists of semi-circular hangers, made from anodized aluminum, sewn into pockets on the exterior of the duct at fixed intervals. These come pre-installed from the factory, which significantly reduces installation time compared to the systems offered by other manufacturers. The All-in-One support are easily removable for maintenance purposes. The appropriate suspension support depends on the diameter of the duct. The AiO Support will cover 180° of the duct’s circumference up to Ø1220 [Ø48”]. For diameters above Ø1220 [Ø48”], hanger coverage decreases due to shipping constraints. All-in-One provides additional support for 90° elbows.


Is it metal or fabric?
• visually appealing
• always open even at shut down (99%)
• minimum strain during startup
• built in hoops means faster installation
•minor tool requirements
• aluminum rails or cable (H-rails or T-rails, cable or od)
• duct is supported 180°
• fully supported elbows
Comparison | |
Classic with and without air turned on |
All-in-One with and without air turned on |
![]() |
![]() |
Regular systems (Classic H-rail) with single suspension turn flat when the air is shut off. This is not the case with All-in-One systems. | Only a slight change of the circular shape occurs with All-in-One when the air is turned off |